[SOLVED] STM32F769NG load to 128MB QSPI flash - modify flashloader file

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] STM32F769NG load to 128MB QSPI flash - modify flashloader file

    Hello All,

    I need to program an QSPI flash (Macronix MX66L1G45, 128MB) via STM32F769NG, but the available default algorithm of ST_STM32F746G_Disco_QSPI.efi flashloader file doesn´t support this project.
    According to JLinkDevices.xml it is the correct algorithm for STM32F769NG.

    Further the pin layout is different to the default on.

    QSPI_CLK need to be PB2
    QSPI_CS need to be PC2
    QSPI_D0 need to be PD3
    QSPI_D1 need to be PD2
    QSPI_D2 need to be PC4
    QSPI_D3 need to be PD4

    How can I modify the existing ST_STM32F746G_Disco_QSPI.efi file (Pin init and/or QSPI init)?? ,is it possible using the Embedded Studio??

    Many thanks in advance,
    Regards
    Stefan
  • Hi Stefan,
    Thank you for your inquiry.

    Could you please open a ticket in our support system for this?
    You can find the required information in my signature.

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.