Hello,
I am using the following commands for programming my NRF52 based custom board:
nrfjprog -f nrf52 --program fimrware.hex --sectorerase --log
nrfjprog -f nrf52 --reset
It was working properly, but suddenly it stopped, and now I get the following log (attached in a file)
I have also triend using J-Link commander, and I get the following
loadfile "firmware.hex"
Downloading file [firmware.hex]...
Writing target memory failed.
I am not sure what has changed and what is causing the problem, I hope you can help me with this
Thanks
I am using the following commands for programming my NRF52 based custom board:
nrfjprog -f nrf52 --program fimrware.hex --sectorerase --log
nrfjprog -f nrf52 --reset
It was working properly, but suddenly it stopped, and now I get the following log (attached in a file)
I have also triend using J-Link commander, and I get the following
loadfile "firmware.hex"
Downloading file [firmware.hex]...
Writing target memory failed.
I am not sure what has changed and what is causing the problem, I hope you can help me with this
Thanks