Dear Sirs at Segger,
I just downloaded the JLink package for Windows V6.82.
As soon as I tried to connect my J-Trace Pro to the IDE, the prompt came up to update the firmware, which I have always done without any glitch.
But this time was different. Don't know how, but something went wrong with the update procedure.
Now, when trying to connect to the probe (e.g. from the command-line JLink) this message pops up:
"The firmware of the connected J-Link will now be restored.
The connected J-Link is running in bootloader mode. This happens if no valid firmware has been found on the J-Link.
Without a valid firmware, J-Link cannot be used."
The restoration process seems to conclude successfully, saying "Firmware updated successfully".
But after connecting the J-Trace probe, the firmware restoration message appears again.
I tried to use the J-Link Configuration tool, but the probe is not listed in the USB panel.
If I connect it to the Ethernet, then it appears in the TCP/IP list. But when trying to update it from here (right-click) I get the message:
"Error, Failed to open DLL".
Now I am really stuck, with my J-Trace no longer usable.
Thanks for any help
Giuseppe
I just downloaded the JLink package for Windows V6.82.
As soon as I tried to connect my J-Trace Pro to the IDE, the prompt came up to update the firmware, which I have always done without any glitch.
But this time was different. Don't know how, but something went wrong with the update procedure.
Now, when trying to connect to the probe (e.g. from the command-line JLink) this message pops up:
"The firmware of the connected J-Link will now be restored.
The connected J-Link is running in bootloader mode. This happens if no valid firmware has been found on the J-Link.
Without a valid firmware, J-Link cannot be used."
The restoration process seems to conclude successfully, saying "Firmware updated successfully".
But after connecting the J-Trace probe, the firmware restoration message appears again.
I tried to use the J-Link Configuration tool, but the probe is not listed in the USB panel.
If I connect it to the Ethernet, then it appears in the TCP/IP list. But when trying to update it from here (right-click) I get the message:
"Error, Failed to open DLL".
Now I am really stuck, with my J-Trace no longer usable.
Thanks for any help
Giuseppe