Hi,
Is it possible to program the Fuse Settings in an Atmel SAME54P20 microcontroller using the Segger Flash Portable Plus in stand-alone mode?
The Fuses are in the NVM User Page starting at address 0x00804000.
It requires that the fuses be read, modified, and written back.
Does the Flash Portable Plus allow programming scripts to be stored in it?
Regards, Mike.
Is it possible to program the Fuse Settings in an Atmel SAME54P20 microcontroller using the Segger Flash Portable Plus in stand-alone mode?
The Fuses are in the NVM User Page starting at address 0x00804000.
It requires that the fuses be read, modified, and written back.
Does the Flash Portable Plus allow programming scripts to be stored in it?
Regards, Mike.