[ABANDONED] Problem writing firmware to controller

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Hi,
    Thank you for your inquiry.
    There is no issue related to NRF52832_XXAA known to us.

    Please find an example Embedded Studio project for the NRF52832_XXAA that is working out of the box on our side here:
    download.segger.com/Fabian/nRF52832_ESSampleProject.zip

    Could you please give it a try and tell us if it works on your side too?

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • Hi,
    I re-uploaded the file.
    Our files are available ~48h when uploaded.

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • This project is working.

    I replaced "Hello World %d!\n" on "-> %d!\n" :
    .... //removed line
    -> 94!
    -> 95!
    -> 96!
    -> 97!
    -> 98!
    -> 99!

    My project is also working with this J-link.

    I can't understand why it didn't work.
    The only difference is that it upgraded the SeggerStudio to version 4.52c

    JLinkExe remained the same.
    Files
    • jlink-connect.txt

      (1.22 kB, downloaded 154 times, last: )
    • rtt_output.txt

      (658 Byte, downloaded 156 times, last: )
  • Hi,
    I am not sure if I understood you correctly.
    You have two J-Links.
    With one J-Link both projects (yours and the one I sent you) are working.
    With the other J-Link, only our project is working.
    Is this correct?

    Is it still not working with one J-Link?
    If so, could you please provide us with the serial numbers of both J-Links?
    Are you using it in the exact same setup (same pc, same os, same board, same cables, etc.)?

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.