Hello,
I have been using the J-Link mainly with MCUXpresso but now tring to create a simple bat file that i call from SW4STM32 to re-flash a ST chip.
I usually invoke this with function key. As i do this hundreds of times per day during development, i need this to be as background as possible.
But whatever i tried it always pops up some weird message boxes that i have to click, on enter details. I am bit lost at this point, is there a
tool in the installed JLink package that actually is pure cmd line executable that can be called, similar as STLink and Cube programmer by ST ?
Yes, i can use the STLink perfectly, but wanted to see if JLink is suited for ST development, seems bit faster on flashing, also if not mistaken
was promising 100 Mbps streaming on the SWO pin, i would love that.
Also i possibly need the SWO viewer to stay connected while re-flashing without pressing Open/Close, is that possible ? All this i prefer to be
fairly standalone, not integrated in some IDE. Thank you!
K.
I have been using the J-Link mainly with MCUXpresso but now tring to create a simple bat file that i call from SW4STM32 to re-flash a ST chip.
I usually invoke this with function key. As i do this hundreds of times per day during development, i need this to be as background as possible.
But whatever i tried it always pops up some weird message boxes that i have to click, on enter details. I am bit lost at this point, is there a
tool in the installed JLink package that actually is pure cmd line executable that can be called, similar as STLink and Cube programmer by ST ?
Yes, i can use the STLink perfectly, but wanted to see if JLink is suited for ST development, seems bit faster on flashing, also if not mistaken
was promising 100 Mbps streaming on the SWO pin, i would love that.
Also i possibly need the SWO viewer to stay connected while re-flashing without pressing Open/Close, is that possible ? All this i prefer to be
fairly standalone, not integrated in some IDE. Thank you!
K.