Hi
I experience flash erase timeout approx. 50% of the times when i try to start debug session on a iMxRT1064 "internal" flash.
Repeating the process normally results in success.
Any idea why this happens.
It used to work in the past but an update top either my setup og Jlink install seems to have affected the stability.
Currently on SEGGER V6.80
Comparing flash [....................] Done.
Erasing flash [....................] Done.
ERROR: Timeout while erasing sectors, RAMCode did not respond in time. (PC = 0xA5A5A5A5, CPSR = 0xA5A5A5A5, LR = 0x81000000)!
Failed to erase sectors.
Br Anders
I experience flash erase timeout approx. 50% of the times when i try to start debug session on a iMxRT1064 "internal" flash.
Repeating the process normally results in success.
Any idea why this happens.
It used to work in the past but an update top either my setup og Jlink install seems to have affected the stability.
Currently on SEGGER V6.80
Comparing flash [....................] Done.
Erasing flash [....................] Done.
ERROR: Timeout while erasing sectors, RAMCode did not respond in time. (PC = 0xA5A5A5A5, CPSR = 0xA5A5A5A5, LR = 0x81000000)!
Failed to erase sectors.
Br Anders