Hello,
I'm using JLink V4.22a and IAR Workbench5.4 to flash and debug a SAM7SE512 target. Everthing works fine except an annoying message box with the message "target system has no power". After confirming a few times the system works again. Often this messagebox appears when executing a Reset in the debugger.
JLink Control Panel shows a core voltage between 1.62V ... 1.75V.
Is it possible to suppress this voltage monitoring?
What are the voltage limits?
In which way can I adjust them?
btw: the same hardware with IAR4 does not show this problem.
Thanks a lot for any help
I'm using JLink V4.22a and IAR Workbench5.4 to flash and debug a SAM7SE512 target. Everthing works fine except an annoying message box with the message "target system has no power". After confirming a few times the system works again. Often this messagebox appears when executing a Reset in the debugger.
JLink Control Panel shows a core voltage between 1.62V ... 1.75V.
Is it possible to suppress this voltage monitoring?
What are the voltage limits?
In which way can I adjust them?
btw: the same hardware with IAR4 does not show this problem.
Thanks a lot for any help