Hi,
I just downloaded the J-Link Software and Documentation pack for Linux, DEB installer, 64-bit in version 6.80 and ran JLinkExe.
When asked for the device, one can usually enter '?' (without the quotes) to get a selection dialogue. This did not happen here. The connection assistant just continued with the next step and thus the connection failed. ... When I then entered the device by hand, it was able to connect.
Display All
Can you reproduce this problem?
Regards
I just downloaded the J-Link Software and Documentation pack for Linux, DEB installer, 64-bit in version 6.80 and ran JLinkExe.
When asked for the device, one can usually enter '?' (without the quotes) to get a selection dialogue. This did not happen here. The connection assistant just continued with the next step and thus the connection failed. ... When I then entered the device by hand, it was able to connect.
Source Code
- Type "connect" to establish a target connection, '?' for help
- J-Link>connect
- Please specify device / core. <Default>: Unspecified
- Type '?' for selection dialog
- Device>?
- Please specify target interface:
- J) JTAG (Default)
- S) SWD
- F) FINE
- I) ICSP
- C) C2
- T) cJTAG
- TIF>s
- Specify target interface speed [kHz]. <Default>: 4000 kHz
- Speed>
- No valid device has been selected.
- J-Link>connect
- Please specify device / core. <Default>: Unspecified
- Type '?' for selection dialog
- Device>STM32F412RE
- Device "STM32F412RE" selected.
- Connecting to target via SWD
- [...]
- Cortex-M4 identified.
Can you reproduce this problem?
Regards