[SOLVED] Recorder Configuration Dialog - Minor GUI bugs

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Recorder Configuration Dialog - Minor GUI bugs

    SystemView 3.12, STM32H743ZI with FreeRTOS

    .. hard to describe:

    1) When opening the Recorder Configuration Dialog, and have a IP Connection configured, the Dialog shows "Serial Number" instead of "IP or Nickname". The correct "IP or Nickname" is only shown after selecting "USB", and then re-selecting "IP".


    2) The same is true for the input field of the RTT group. You have to select "Auto", and "Address" again, before the field is visible.


    3) When switching between "Address" and "Search Range", it seems that the same variable is shared for both settings.

    Example:
    * Click on Address, enter "0x2001c2f4"
    * Click on Search Range, I would expect an empty field, or at least the range that was set last time.
    Images
    • 2020-05-01 18_08_20-Recorder Configuration _ SEGGER SystemView V3.12.png

      14.06 kB, 382×349, viewed 43 times
  • Hello,

    Thank you for your feedback.
    1 and 2 are reproducible and will be fixed.

    3: Yes the same variable is used, however this is no bug as a user usually would pick one of the settings and keep it and not switch between configurations often.

    Best regards,
    Nino
    Please read the forum rules before posting: Forum Rules

    Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.