[ABANDONED] Why can't I write to memory permanently using J-Link Commander?

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Why can't I write to memory permanently using J-Link Commander?

    Hi all,

    I am using J-Link Commander with Nordic chip nrf52382. When I try to write to a memory location using "w1" command, I can see that it is written successfully by reading it using "mem" command. However, if I reconnect the chip again using "connect" command, the memory at that address returns to the original value. Is that how the "w1" command works or is there something that I do wrong?

    Thank you.
  • Hello,

    Thank you for your inquiry.
    What is the address you are writing to?

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.