Hi all,
I am using J-Link Commander with Nordic chip nrf52382. When I try to write to a memory location using "w1" command, I can see that it is written successfully by reading it using "mem" command. However, if I reconnect the chip again using "connect" command, the memory at that address returns to the original value. Is that how the "w1" command works or is there something that I do wrong?
Thank you.
I am using J-Link Commander with Nordic chip nrf52382. When I try to write to a memory location using "w1" command, I can see that it is written successfully by reading it using "mem" command. However, if I reconnect the chip again using "connect" command, the memory at that address returns to the original value. Is that how the "w1" command works or is there something that I do wrong?
Thank you.
