Bus Fault

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • I trying to uses an ST7789 interface with FreeRTOS on a Cypress POC 6 system. This is my first project using emWin, so the most likely source of my problem is a setup/configuration problem.

      The code is crashing out with a bus fault error. After initializing the GUI system, I did a simple GUI_DrawLine( 0,0, 1,1). The code gets to the step shown in the attached FatalStep.png. When I do a "step into" on that step, the code encounters a bus fault - see BusFault.png.

      Can you provide any suggestions to fix this?

      Thanks,

      Ed H.




      Images
      • BusFault.PNG

        44.99 kB, 736×745, viewed 419 times