[ABANDONED] Ozone crashes when pausing execution outside of elf file

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Ozone crashes when pausing execution outside of elf file

    Ozone V3.10g with a bootloader elf file crashes if Debug.Halt(); occurs after it leaves the bootloader section of memory. On another device and with a different bootloader, this does not occur using Ozone. The SEGGER J-Link Pro and Ultra+ are being used as debuggers. The targets are STM32F4.

    Cheers,
    Joe

  • Hello Joe,

    Thank you for your inquiry.
    Such an issue is not known to us. Could you provide some more information about your setup?
    What host OS are you running Ozone on?
    Are you using a custom or eval board?
    Could you provide an example project for reproduction that would run on an eval board?
    When setting up the bootloader projects did you consider the following steps?
    wiki.segger.com/Debug_on_a_Target_with_Bootloader
    wiki.segger.com/Debug_Bootload…ion_in_same_Ozone_project

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.