How to setup SES solution options to connect to a remote JLink through a tunnel?

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Hello,

      Thank you for your inquiry.
      Such an issue is not known to us.
      A how to is explained here:
      wiki.segger.com/Connect_to_rem…_via_J-Link_Tunnel_Server

      Are you following these exact steps?
      What Embedded Studio version are you using?
      What is the S/N of the J-Link you are using?
      Do you get any error messages?
      Are you using any firewalls in your network that might block traffic?

      Best regards,
      Nino
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support you can contact us via our support system: segger.com/ticket/

      Or you can contact us via e-mail.
    • New

      Hello,

      Could you try the following in Embedded Studio?
      ip tunnel:682116514::jlink.segger.com

      Does this work?

      Best regards,
      Nino
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support you can contact us via our support system: segger.com/ticket/

      Or you can contact us via e-mail.
    • New

      Yes that works!

      Is there some kind of timeout on the connection from remote server to the tunnel server? It seems I cannot connect anymore after some time, even though the remote server still indicates "Waiting for client authentication".

      The main reason I want to use the tunnel connection is because of the problem as described in:
      Stopping a debug session in one SES instance disconnects JLINK in other SES instance
    • New

      Hello,

      Good to hear that connection is working now.
      J-Link Remote Server has only a timeout if server replys take longer than 5 s. So if the ping between Client->Tunnel->Remote Server is more than 5 seconds it can come to timeouts but only after a initial connection is established.

      Best regards,
      Nino
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support you can contact us via our support system: segger.com/ticket/

      Or you can contact us via e-mail.