STM32H745 Dual Core Development/Debugging

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • STM32H745 Dual Core Development/Debugging

      Does Segger have any examples or notes for the recommended way to develop/debug code for dual core processors in Embedded Studio? I am working with the STM32H745ZI processor and would like some guidance. I initially imported an ST STM32H745 Nulceo dual core GPIO example but it did not link the firmware to the right address spaces. I separated the CM4 and CM7 imported code into two projects in one solution and changed the flash/ram address space for each one. That seems to work but I'm wondering if it is the proper way to develop for dual core?

      For debugging, are there any tips on debugging dual core processors? Is it possible to view registers from both cores during a debug session or can I only see the registers for the core being debugged?

      Best Regards!
    • Hello,

      Thank you for your inquiry.
      A how to debug and setup multi core projects in Embedded Studio is explained here:
      wiki.segger.com/NXP_LPC43xx_se…4350_with_Embedded_Studio


      Best regards,

      Nino
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support you can contact us via our support system: segger.com/ticket/

      Or you can contact us via e-mail.