Hello,
I am using J-Flash V6.60f to flash a STM32G431CB (SWD interface) with a given .hex file.
Everything goes well until "Restoring" (message at the end of the message):
...
Start of restoring
- ERROR: Timeout while restoring target, RAMCode did not respond in time. (PC = 0x00000000, CPSR = 0x00000000, LR = 0x21000000)!
- ERROR: Failed to restore target. RAMCode never stops
- End of restoring
...
What does this step exactly?
How can I get rid of this issue?
Thanks forward for your help,
Kind regards,
Sébastien
-------------------------------------------------------------
Programming and verifying target (12968 bytes, 2 ranges) ...
- Checking if selected data fits into selected flash sectors.
- Start of preparing flash programming
- End of preparing flash programming
- Start of determining dirty areas in flash cache
- End of determining dirty areas
- CPU is running at 56000 kHz.
- Start of flash programming
- Programming range 0x08000000 - 0x080037FF ( 7 Sectors, 14 KB)
- End of flash programming
- Flash programming performed for 1 range (14336 bytes)
- 0x8000000 - 0x80037FF ( 7 Sectors, 14 KB)
- Start of verifying flash
- End of verifying flash
- Start of restoring
- ERROR: Timeout while restoring target, RAMCode did not respond in time. (PC = 0x00000000, CPSR = 0x00000000, LR = 0x21000000)!
- ERROR: Failed to restore target. RAMCode never stops
- End of restoring
- ERROR: Failed to program and verify target
Disconnecting ...
- Disconnected
I am using J-Flash V6.60f to flash a STM32G431CB (SWD interface) with a given .hex file.
Everything goes well until "Restoring" (message at the end of the message):
...
Start of restoring
- ERROR: Timeout while restoring target, RAMCode did not respond in time. (PC = 0x00000000, CPSR = 0x00000000, LR = 0x21000000)!
- ERROR: Failed to restore target. RAMCode never stops
- End of restoring
...
What does this step exactly?
How can I get rid of this issue?
Thanks forward for your help,
Kind regards,
Sébastien
-------------------------------------------------------------
Programming and verifying target (12968 bytes, 2 ranges) ...
- Checking if selected data fits into selected flash sectors.
- Start of preparing flash programming
- End of preparing flash programming
- Start of determining dirty areas in flash cache
- End of determining dirty areas
- CPU is running at 56000 kHz.
- Start of flash programming
- Programming range 0x08000000 - 0x080037FF ( 7 Sectors, 14 KB)
- End of flash programming
- Flash programming performed for 1 range (14336 bytes)
- 0x8000000 - 0x80037FF ( 7 Sectors, 14 KB)
- Start of verifying flash
- End of verifying flash
- Start of restoring
- ERROR: Timeout while restoring target, RAMCode did not respond in time. (PC = 0x00000000, CPSR = 0x00000000, LR = 0x21000000)!
- ERROR: Failed to restore target. RAMCode never stops
- End of restoring
- ERROR: Failed to program and verify target
Disconnecting ...
- Disconnected