[ABANDONED] Error reported: Faild to connect to target

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Error reported: Faild to connect to target

    Hi,

    I used today the No-Commercial-License of Segger Embbeded Studio for ARM V4.30c (32-bit). We want to test the development environment before we buy it. Now I have a problem. I would like to test debugging and flashing with the J-Link Plus Adapter to the target. But I always get the error message "No idcode detected". Is this not allowed with the non-commercial license?

    BR
    Udo
  • Hello Udo,

    Thank you for your inquiry.
    There are no technical restrictions in the non commercial/evaluation version of Embedded Studio.
    This sounds like a connection setup issue.
    What target device are you looking to connect to?
    Is it a custom board or eval board? If eval which one?
    Is connection working using J-Link Commander?
    wiki.segger.com/J-Link_cannot_…ty_using_J-Link_Commander

    Best regards,
    Nino
    Please read the forum rules before posting: Forum Rules

    Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.