[SOLVED] Ozone: How to view more instructions in trace

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Ozone: How to view more instructions in trace

    I am debugging an NXP MKL26Z256, and Ozone is out of the box working fantastically for me. I was able to get MTB tracing set up in a minute, which is great! But the instruction trace only shows me a maximum of 64 instructions (source/destination pairs), Is there any way to increase the number of instructions I can view in Ozone? It's hard for me to tell if the trace buffer is larger or not, but if I need to increase the size of the trace buffer, how would I do that in Ozone?

    Thanks!

  • Hello,

    Thank you for your inquiry.
    The default buffer size is 512 bytes. But the MTB can be configured to use more RAM if available for tracing.
    How to configure this is explained here:
    wiki.segger.com/MTB_specifics

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.