Problem while programming STM32F103RG

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Problem while programming STM32F103RG

      New

      Whenever I try to program my device STM32F103RG with J-Link Plus & J-Flash, it throws the following error:

      Selected Data (0x8000000 - 0x8007823) does not fit into selected flash sectors.

      However, I'm able to program the same data file with ST's own programming utility STM32CubeProgrammer & ST-Link connection.

      The base address 0x8000000 is correct as it is getting selected as default in CubeProgrammer as well.

      Attached image shows my project settings.
      Are there any additional settings I should look after?
      Images
      • J-Flash_STM32F103RG_Project_Settings.png

        73.24 kB, 924×709, viewed 2 times