[SOLVED] Invalid packet received. Recording stopped.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Invalid packet received. Recording stopped.

    Hello,
    I'm struggling with SystemView v2.52d to record anything longer than 5s, through a J-link Plus.
    I get the error "Invalid packet received. Recording stopped.".

    My configuration is SWD 4000 KHz, which is used by the debugger when I debug.
    I tried to use SystemView with or without the debugger launched, there are no differences.

    I sometimes manage to record some events, so I reduced the number of signals, but this doesn't help.
    Even if I try to save the file, the recorded data can't be re-opened later (!).

    I read the doc, but I don't manage to have a proper setup.
    Where can I start?
  • Hello,

    Thank you for your inquiry.
    Troubleshooting steps for this error message can be found on our website in the FAQ section:
    segger.com/products/development-tools/systemview/

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.