Hi everyone,

I am Huy. Currently, i am working with the board STM32L4R9IDISC that is on J-Link.

To flash this board, i did as instruction on the link segger.com/products/debug-prob…echnology/flash-download/ at the section J-Link Commander.
However, as i reach to "J-Link> loadbin <PathToBinFile>, <programmingaddress>". The screen displayed "Failed to open file".

Could someone instruct me to fix this error and flash this board?

Thank you very much in advance.

P/S: the below is the Commander scree.

I also tried to used J-Flash Lite but still the error of "Could not download file" appeared.

I chose SWD interface and 4000 kHz in both Commander and Lite.

I solved the issue already. I just chose a wrong device.