[ABANDONED] Not able to load binary file into Flash - ADuCM362

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Not able to load binary file into Flash - ADuCM362

    Hello
    I tried to load *.bin file to ADuCM362 controller through SWD using J-Flash, it will connect to target but I not able to load executable into flash.
    It is giving programming failed @ address 0x00002338 (Block verification error).

    Please suggest what was the issue and what changes i need to make it work properly.

    i attached the screenshot of the error and log, Please find the attachment.

    Regards,
    Manjunath R
    Images
    • Segger_error.JPG

      54.76 kB, 925×227, viewed 351 times
  • Hi Manjunath,
    Thank you for your inquiry.

    Such an issue is not known to us.

    1) Could you please provide us with the full log output of J-Flash?
    2) Could you please send us a J-Link log file? How to enable:
    wiki.segger.com/J-Link_DLL#Enable_J-Link_Log_File

    Best regards,
    Fabian Federschmidt
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.