[SOLVED] Flasher ARM in stand-alone mode and red led's signification

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Flasher ARM in stand-alone mode and red led's signification

    Hello,
    I use the ARM Flasher in stand-alone mode.
    When I start a prog, sometimes the red led lights up.
    Is it possible to know the type of error that occurs when the red light is on?
    Is there a internal log file ?
    Regards,
    Phil
  • Hello Phil,

    there is an internal log file. If you mount the Flasher as MSD device, you can open the Flasher.log. To do so, press the PRG button while you plug in the USB cable.
    In addition you can record the outputs on the RS232 (9600 baud, 8N1) connector or use the Telnet connection on the LAN interface.

    For further support we would need the output of the terminal, the device name and the JFlash-Project file (*.jflash).

    Best regards,
    Michael