[ABANDONED] Flasher ARM for Renesas R7FS7G27G definition problem

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Flasher ARM for Renesas R7FS7G27G definition problem

    Hi,
    I need to use the stand alone Flasher ARM programmer for the Renesas R7FS7G27G componant with J-flasher software
    But the definition of flash Bank 1 (Internal data flash) is not good. it should be an area of 1024 * 64 bytes sector but in fact it is 256 * 256 bytes.

    How can I fix the problem?
    Thanks
    Phil
    Images

    • segger.png

      39.27 kB, 696×547, viewed 452 times

    The post was edited 2 times, last by Phil ().

  • Hi Phil,
    yes you are right concerning the sector size of 64 bytes instead of 256 bytes.
    Unfortunately, we had to summarize the sectors to a size of 256bytes as the minimum alignment for flash programming is 256 bytes.
    Therefore you can also erase the data sectors only in 256byte steps.

    Best regards,
    Sebastian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.