[SOLVED] Flash issue for CYT2B75CAE

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Flash issue for CYT2B75CAE

    Hi

    I am facing issue while flashing the CYT2B75CAE board.
    I am getting following error in attachment.

    I tried erase option in Jlink that is also giving the same error.

    Cause: Other day I misakenly chose the device as CYT2B95CAE instead CYT2B75CAE, then after I am facing issue.

    Please suggest on this.

    Thank
    Sumit
    Images
    • JFlash_error.jpg

      153.59 kB, 901×492, viewed 937 times
    • jlink_err.jpg

      163.9 kB, 1,366×738, viewed 787 times
  • Hi Sumit,

    can you please try sector erase (F3) or chip erase in J-Flash (F4) after deactivating "Perform Blank Check within "Project settings->Performance", as you can see in my screenshot?
    There seems to be an issue when flash memory is undefined. After successfully erasing the flash, you should read "0xFF" again as blank value instead of "--".

    Regards,
    Sebastian
    Images
    • J-Flash_BlankCheckOff.PNG

      29.57 kB, 936×706, viewed 402 times
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.