[ABANDONED] SEGGER J-Link GDB Server V6.34c - Terminal output channel Connection closed by the GDB server.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] SEGGER J-Link GDB Server V6.34c - Terminal output channel Connection closed by the GDB server.

    I am getting this error message, only after using breakpoints. I have swapped debuggers but no joy. This just started out of the blue. Any help will be appreciated.

    SEGGER J-Link GDB Server V6.34c - Terminal output channel
    Connection closed by the GDB server.


    Connecting to J-Link...
    J-Link is connected.
    Firmware: J-Link V10 compiled Aug 23 2018 09:46:11
    Hardware: V10.10
    S/N: 50115113
    Feature(s): GDB
    Checking target voltage...
    Target voltage: 3.26 V
    Listening on TCP/IP port 2331
    Connecting to target...Connected to target
    Waiting for GDB connection...Connected to 127.0.0.1
    Reading all registers
    Read 4 bytes @ address 0x000074FE (Data = 0x4807E7FD)
    Read 2 bytes @ address 0x000074FE (Data = 0xE7FD)
    Received monitor command: speed 1000
    Target interface speed set to 1000 kHz
    Received monitor command: speed auto
    Select auto target interface speed (2000 kHz)
    Received monitor command: flash breakpoints 0
    Flash breakpoints disabled
    Read 4 bytes @ address 0x00001FC0 (Data = 0x00000000)
    Read 4 bytes @ address 0x00001FC4 (Data = 0x002D0403)
    Read 4 bytes @ address 0x00001FC8 (Data = 0x00000000)
    Read 4 bytes @ address 0x00001FCC (Data = 0xB24397BA)
    GDB closed TCP/IP connection
  • Hello,

    Thank you for your inquiry.
    The J-Link software version you are using is a couple of months old. Could you give the latest software version a try?
    segger.com/downloads/jlink/#J-…twareAndDocumentationPack

    Does that solve the issue?

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • Hello,

    Could you provide a J-Link log of the session?
    wiki.segger.com/Enable_J-Link_log_file

    You write that it started out of the blue. Did you change anything in your setup? Other cables, other USB input, other host PC, firewalls etc.?

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.