[SOLVED] Embedded studio simulator mode peripheral register change

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Embedded studio simulator mode peripheral register change

    Hello,
    I am evaluating segger embedded studio ide.
    i wrote a code for stm32 board and try to simulate it . but the peripheral registers are not getting affected.
    it is constantly showing 0xcdcdcdcd .
    why is that ?
    I have not connected any hardware and using simulator mode
    thank you .

  • Hello,

    Thank you for your inquiry.
    Target specific Peripheral registers are not part of the simulation. Only ARM CPU registers will be simulated.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.