[SOLVED] RE-OPEN 5.05.10 FLASHER 5 PRO - Error 55 - CRC check in programmer - failed

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] RE-OPEN 5.05.10 FLASHER 5 PRO - Error 55 - CRC check in programmer - failed

    Hi,


    have just have bought 5.05.10 fLASHER 5 PRO programmer and seeing same problem. Have used the same programmer in past with no problems.

    Attempted to use the .BIN file method to update and seemed to work. I am running V214B. Notice on screen however that the FIRMWARE version is V214A For FLASHER HW 6.00 S/N 581300704. Was expecting V214B,

    Do not see any Firmware error. Can also run download Firmware from V214B and get Result O.K. But still says on screen V214A.

    When attempt to OPTIONS > DOWNLOAD FILE TO FLASHER get the following responses

    1. CRC check in programmer failed.
    2. Then Write operation to SD card failed.

    Can CLEAR and do blank check and PASSES. When try to do any programming get the same error as above.

    Any suggestion on what to try next?

    Thanks,

    Steve
  • Hello Steve,

    Thank you for your inquiry.
    Please not that this forum is no official support forum.
    To get support please fill our official support form to get in tough with our engineers directly.
    You can find the needed contact information in my signature.
    To make sure no information gets lost between channels this thread will be closed now.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.