[SOLVED] unable to unsercure and secured chip

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] unable to unsercure and secured chip

    Hello,

    When programming the ATMEL microcontroller (ATSAM10d14AM) with SW connection using labview, a popup showed asking me to allow securing the microcontroller after programming and i miscrossed at securing. Now I am unable to erase, or reprogram the microcntoller and I cannot unsecure it.
    What should I do to unsecure the microcontroller from now on ?

    PS: I installed the V6.12 and V6.44 J-link and the Segger FLASH programmer.