Hello,
When programming the ATMEL microcontroller (ATSAM10d14AM) with SW connection using labview, a popup showed asking me to allow securing the microcontroller after programming and i miscrossed at securing. Now I am unable to erase, or reprogram the microcntoller and I cannot unsecure it.
What should I do to unsecure the microcontroller from now on ?
PS: I installed the V6.12 and V6.44 J-link and the Segger FLASH programmer.
When programming the ATMEL microcontroller (ATSAM10d14AM) with SW connection using labview, a popup showed asking me to allow securing the microcontroller after programming and i miscrossed at securing. Now I am unable to erase, or reprogram the microcntoller and I cannot unsecure it.
What should I do to unsecure the microcontroller from now on ?
PS: I installed the V6.12 and V6.44 J-link and the Segger FLASH programmer.