[ABANDONED] Debug Does Not Stop at initial break point

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Debug Does Not Stop at initial break point

    My code builds and downloads to the debugger (J-Link Ultra+). However, once it has loaded it seems to start running, and on a break is running in an unidentifiable area of code. This was previously working and I'm not aware of having made any changes. I have tried older, known working code and they exhibit the same behaviour.

    I'm using MacOS 10.14.3 and SES 4.16

    Where do i start debugging this?
  • Hello,

    Thank you for your inquiry.
    So you want to start debugging from the reset hanlder and not from main correct?
    In that case starte the debug session with F11 instead of F5. This will "step into" the application and you will halt at the absolute beginning of your application.
    Is that what you were looking for?

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.