Ozone : trace point start and stop has no effect

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Ozone : trace point start and stop has no effect

      Hello,

      With a J-Trace cortex M and stm32F429ZET6 :

      When I run the soft with ozone, I have the full trace.
      Now, I want to trace only some portions of the code. I added a start tracepoint and a stop tracepoint.
      I'm sure that the execution goes through this code. I run the soft, pause it after some iteration and I there's
      nothing in the trace window.

      Is there some thing I've forgotten to do?

      Thanks
      Julien
      Images
      • trace2.jpg

        129.01 kB, 738×514, viewed 10 times