Hi there,
i have a IMXRT1060-EVK BOARD with ISSI QSPI Flash(IS25WP128).
i have "SEGGER Flasher ARM JTAG" and jLink version below
SEGGER J-Link Commander V6.42c (Compiled Feb 11 2019 17:06:25)
i am a beginner of jtag.
i want to write U-boot to QSPI Flash using JTAG.
i deleted the QSPI FLASH as follows, and U-BOOT write to QSPI FLASH.
i do flash erase command "erase all" -> "exec EnableEraseAllFlashBanks" -> "erase all"
attached file "s_01.png"
i do flash write command "loadfile <path> <addr>"
attached file "s_02.png"
but, U-BOOT is not working (U-boot binary is a normal working binary)
is this the right way my proceed?
i don't know why u-boot is not work.
could you give me a guide?
please help me. fixed this problem.
thank you.
i have a IMXRT1060-EVK BOARD with ISSI QSPI Flash(IS25WP128).
i have "SEGGER Flasher ARM JTAG" and jLink version below
SEGGER J-Link Commander V6.42c (Compiled Feb 11 2019 17:06:25)
i am a beginner of jtag.
i want to write U-boot to QSPI Flash using JTAG.
i deleted the QSPI FLASH as follows, and U-BOOT write to QSPI FLASH.
i do flash erase command "erase all" -> "exec EnableEraseAllFlashBanks" -> "erase all"
attached file "s_01.png"
i do flash write command "loadfile <path> <addr>"
attached file "s_02.png"
but, U-BOOT is not working (U-boot binary is a normal working binary)
is this the right way my proceed?
i don't know why u-boot is not work.
could you give me a guide?
please help me. fixed this problem.
thank you.