[SOLVED] How much RAM is required for J-Link to proper work with Flash breakpoints

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] How much RAM is required for J-Link to proper work with Flash breakpoints

    Hi,

    i wasn't able to find anything in the manual about this. I want to replace the Ram area J-Link uses for Flash breakpoints (reprogramming the flash). I think the command for this is "SetWorkRam".
    I only found a Wiki-Page which says the amount of Ram should not be lower than 512 bytes. But what is the recommended size of RAM J-Link needs to work properly with Flash Breakpoints for CFI flashes ?

    Thanks for your help.

    Hans
  • Hi Hans,

    We received this inquiry via Supportsystem as well.
    To keep all information in one place this thread will be closed now.

    For everyone else, the minimum recommended RAM size is 5-6 kB.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.