Hi,
i wasn't able to find anything in the manual about this. I want to replace the Ram area J-Link uses for Flash breakpoints (reprogramming the flash). I think the command for this is "SetWorkRam".
I only found a Wiki-Page which says the amount of Ram should not be lower than 512 bytes. But what is the recommended size of RAM J-Link needs to work properly with Flash Breakpoints for CFI flashes ?
Thanks for your help.
Hans
i wasn't able to find anything in the manual about this. I want to replace the Ram area J-Link uses for Flash breakpoints (reprogramming the flash). I think the command for this is "SetWorkRam".
I only found a Wiki-Page which says the amount of Ram should not be lower than 512 bytes. But what is the recommended size of RAM J-Link needs to work properly with Flash Breakpoints for CFI flashes ?
Thanks for your help.
Hans