Application log started
- J-Flash V6.45a (J-Flash compiled Mar 6 2019 16:49:46)
- JLinkARM.dll V6.45a (DLL compiled Mar 6 2019 16:49:14)
Creating new project ...
- New project created successfully
Connecting ...
- Connecting via USB to J-Link device 0
- J-Link firmware: J-Link V10 compiled Mar 1 2019 16:57:49
- Device "R5F52205" selected.
- FINE: Found Renesas device
- Found Renesas RX210 device (MCU_DR: 0xD013)
- Starting debugger authentication...
- Debugger authenticated successfully.
- Endian: little
- Enabling ongoing debug mode.
- ERROR: Failed to enable ongoing debug mode for debugging.
Specific core setup failed.
- Target interface speed: 500 kHz (Auto)
- VTarget = 5.004V
- ERROR: Failed to connect.
Could not establish a connection to target.
===============
Can a help me?
Sergey
- J-Flash V6.45a (J-Flash compiled Mar 6 2019 16:49:46)
- JLinkARM.dll V6.45a (DLL compiled Mar 6 2019 16:49:14)
Creating new project ...
- New project created successfully
Connecting ...
- Connecting via USB to J-Link device 0
- J-Link firmware: J-Link V10 compiled Mar 1 2019 16:57:49
- Device "R5F52205" selected.
- FINE: Found Renesas device
- Found Renesas RX210 device (MCU_DR: 0xD013)
- Starting debugger authentication...
- Debugger authenticated successfully.
- Endian: little
- Enabling ongoing debug mode.
- ERROR: Failed to enable ongoing debug mode for debugging.
Specific core setup failed.
- Target interface speed: 500 kHz (Auto)
- VTarget = 5.004V
- ERROR: Failed to connect.
Could not establish a connection to target.
===============
Can a help me?
Sergey
The post was edited 1 time, last by tereks ().