I have connected the j-link plus/J-link base to NXP ls2088ardb board. I am getting the following error.

Failed to connect to target.
No idcode detected.
Please check connection and target interface type.

I have tried to check with the J-Link Commander V6.44, I got the below message.

Connecting to J-Link via USB...O.K.
Firmware: J-Link V10 compiled Mar 1 2019 16:57:49
Hardware version: V10.10
S/N: XXXXXX
License(s): RDI, FlashBP, FlashDL, JFlash, GDB
VTref=1.806V

Type "connect" to establish a target connection, '?' for help
J-Link>connect
Please specify device / core. <Default>: CORTEX-A5
Type '?' for selection dialog
Device>?

When I tried to check the device in the list, I could not find cortex-A72, even I could not find in the SEGGER Embedded Studio for ARM 4.12

When I check the site it is supported, Please find the detail in the below link, it shows Cortex-A72 was supported

segger.com/products/debug-prob…pported-cpus-and-devices/

Can you please let me know am I missing something here?

I have added ticket as well

-Removed ticket link-
Admin: Please do not post links to your tickets in public places.

Hello Team,

Please find the picture attached to email where i could not find the in the list.