[ABANDONED] Can't find GPIO registers in register window during debug

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Can't find GPIO registers in register window during debug

    I run a project with target nRF52840_xxAA. I want to see the status of GPIO registers during debug. I open the register window on the Group button , but all I see is GPIOE .
    1. Where can I found them?
  • Hello,

    Thank you for your inquiry.
    Could you provide a screenshot that shows the issue?
    Which register file is defined in your project? You can find this in project options under Register Definition File

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.