Hi there,
I have an IMXRT 1021 144-pin version board with QSPI connected on the secondary pinmux option (i.e. BOOT_CFG[2:1]=111b). I cannot get the flash to erase or program in this configuration using JTrace and V6.43c. I don't see anything obvious wrong in my wiring or configuration.
Is the IMXRT1021 flash utility set up to recognise the connection of the flash chip? If so, how do I configure it? If not, can it be added?
Regards
DAVE
I have an IMXRT 1021 144-pin version board with QSPI connected on the secondary pinmux option (i.e. BOOT_CFG[2:1]=111b). I cannot get the flash to erase or program in this configuration using JTrace and V6.43c. I don't see anything obvious wrong in my wiring or configuration.
Is the IMXRT1021 flash utility set up to recognise the connection of the flash chip? If so, how do I configure it? If not, can it be added?
Regards
DAVE