Hi,
Does J-Link (or J-Trace) support NXP i.MX8M chips yet? I haven't found it on the "supported devices" list, only here: wiki.segger.com/IMX_Series_Devices. However, Cortex-A53 target is supposed to be supported in the latest release.
I have tried by selecting "Cortex-A53" and the result is as follows:
Display All
Any ideas how to make it attach to the target?
I'm using software version V6.42b
Thanks,
Jakub
Does J-Link (or J-Trace) support NXP i.MX8M chips yet? I haven't found it on the "supported devices" list, only here: wiki.segger.com/IMX_Series_Devices. However, Cortex-A53 target is supposed to be supported in the latest release.
I have tried by selecting "Cortex-A53" and the result is as follows:
Source Code
- J-Link>connect
- Please specify device / core. <Default>: MK20DX256XXX7
- Type '?' for selection dialog
- Device>Cortex-A53
- Please specify target interface:
- J) JTAG (Default)
- S) SWD
- T) cJTAG
- TIF>J
- Device position in JTAG chain (IRPre,DRPre) <Default>: -1,-1 => Auto-detect
- JTAGConf>
- Specify target interface speed [kHz]. <Default>: 4000 kHz
- Speed>100
- Device "CORTEX-A53" selected.
- Connecting to target via JTAG
- TotalIRLen = 4, IRPrint = 0x01
- JTAG chain detection found 1 devices:
- #0 Id: 0x5BA00477, IRLen: 04, CoreSight JTAG-DP
- Failed to power up DAP
- Could not measure total IR len. TDO is constant high.
- Could not measure total IR len. TDO is constant high.
- Could not measure total IR len. TDO is constant high.
- Could not measure total IR len. TDO is constant high.
- Cannot connect to target.
I'm using software version V6.42b
Thanks,
Jakub