[SOLVED] program Atmega32p using j-link edu

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] program Atmega32p using j-link edu

    Hi.
    After arduino was enough i decided to go to bare metal programming.
    i have an Atmega32p mcu and i would like to program it using my j-link edu.
    I assume i can use JLinkExe to save a bin program from meme area 0, but:
    1. how to i physically connect the j-link ? i mean which wire goes to which pin of the mcu ?
    2. is it possible to use j-link with avrdude ? what type do i choose in avrdude ?
    3. same question regarding debugging with gdb and how to wire j-link to the mcu to do so.

    * if need be i also have Atmel's JTag to avr jtag\swd\spi adapter.



    the reason i'm asking of course is cause i couldn't find the answers somewhere else...

    The post was edited 1 time, last by eyal.gal ().

  • Hello,

    AVR microcontrollers (ATMega etc.) are not supported by J-Link.
    A list with supported core types can be found here:

    segger.com/products/debug-prob…pported-cpus-and-devices/

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.