Hi.
After arduino was enough i decided to go to bare metal programming.
i have an Atmega32p mcu and i would like to program it using my j-link edu.
I assume i can use JLinkExe to save a bin program from meme area 0, but:
1. how to i physically connect the j-link ? i mean which wire goes to which pin of the mcu ?
2. is it possible to use j-link with avrdude ? what type do i choose in avrdude ?
3. same question regarding debugging with gdb and how to wire j-link to the mcu to do so.
* if need be i also have Atmel's JTag to avr jtag\swd\spi adapter.
the reason i'm asking of course is cause i couldn't find the answers somewhere else...
After arduino was enough i decided to go to bare metal programming.
i have an Atmega32p mcu and i would like to program it using my j-link edu.
I assume i can use JLinkExe to save a bin program from meme area 0, but:
1. how to i physically connect the j-link ? i mean which wire goes to which pin of the mcu ?
2. is it possible to use j-link with avrdude ? what type do i choose in avrdude ?
3. same question regarding debugging with gdb and how to wire j-link to the mcu to do so.
* if need be i also have Atmel's JTag to avr jtag\swd\spi adapter.
the reason i'm asking of course is cause i couldn't find the answers somewhere else...