Hello,
im having trouble to connect to Cypress FCR4 MB9DF125.
It's not DEV kit it's car dashbord.
When i try to connect i get ERROR: Trying to halt the Core caused the StickyError flag to be set!
Any help will be highly appreciated.
Display All
Kind regards.
im having trouble to connect to Cypress FCR4 MB9DF125.
It's not DEV kit it's car dashbord.
When i try to connect i get ERROR: Trying to halt the Core caused the StickyError flag to be set!
Any help will be highly appreciated.
Source Code
- SEGGER J-Link Commander V6.12i (Compiled Feb 3 2017 15:25:11)
- DLL version V6.12i, compiled Feb 3 2017 15:24:41
- Script file read successfully.
- Processing script file...
- J-Link connection not established yet but required for command.
- Connecting to J-Link via USB...O.K.
- Firmware: J-Link Ultra V4 compiled Oct 26 2018 12:04:46
- Hardware version: V4.00
- S/N: 504500117
- License(s): RDI, FlashBP, FlashDL, JFlash, GDB
- VTref = 3.404V
- Target connection not established yet but required for command.
- Device "MB9DF125" selected.
- --- FSEU script --- InitTarget() from JLinkScript is executed
- --- FSEU script --- MCU reset
- --- FSEU script --- OK: Debug port powered up
- --- FSEU script --- OK: ARM JTAG-DP detected (JTAG IDCODE: 0x4ba00477)
- --- FSEU script --- OK: SCCFG_STAT2_DBGRDY is set, whole MCU can now be accessed (if unsecured))
- --- FSEU script --- OK: Correct security key entered, MCU unlocked
- --- FSEU script --- ERROR: Trying to halt the Core caused the StickyError flag to be set!
- --- FSEU script --- ERROR: Accessing Watchdog registers caused the StickyError flag to be set!
- --- FSEU script --- ERROR: Trying to change System RAM wait cycles caused the StickyError flag to be set!
- TotalIRLen = 4, IRPrint = 0x01
- ARM AP[0]: 0x44770001, AHB-AP
- ARM AP[1]: 0x24770002, APB-AP
- ROMTbl 0 [0]: 00001003, CID: 00000000, PID:00-00000000
Kind regards.