Segger Linker 2.25

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Segger Linker 2.25

      I use a µC XMC4800, this controller flash has differnt address section for cached /uncached access

      PMU0 Program Flash Bank(non-cached) 2.0 Mbyte at 0C000000
      PMU0 Program Flash Bank(cached space) 2.0 Mbyte at 08000000
      ( different address space for the same physical memory, mapped in the non-
      cached address space )

      With the GNC linker i can set a VMA(virtual memory address) and a LMA(load memory address)

      For example:

      MEMORY
      {
      FLASH_0_cached(RX) : ORIGIN = 0x08000000, LENGTH = 0x00010000
      FLASH_0_uncached(RX) : ORIGIN = 0x0C000000, LENGTH = 0x00010000
      }

      .reset :
      {
      KEEP(*(.reset));
      } > FLASH_0_cached AT > FLASH_0_uncached


      Is this also possible with the segger linker ?

      Thanks,
      Embedded
    • Hello,

      Thank you for your inquiry.
      Virtual memory addresses are not supported by SEGGER Linker.

      Best regards,
      Nino
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support contact us per e-mail.
      Alternatively our support ticketing system can be used as well: segger.com/ticket/