Pre/Post Load Steps

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Pre/Post Load Steps

      Is it possible to do pre/post loading steps similar to the pre/post build steps? The chips I'm loading have MAC addresses that get erased due to the memory layout so it would be nice to be able to read it in and write it back out automatically instead of manually loading it afterwards.
    • Hello,

      Thank you for your inquiry.
      Pre/Post load steps are not available in Embedded Studio. We suggest moving the MAC address if possible to a memory sector where no other code is, because J-Link will only erase sectors that are part of your downloaded image and are different from the current memory content.
      That way your MAC address would survive new programming attempts.

      Best regards,
      Please read the forum rules before posting: Forum Rules

      Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support contact us per e-mail.
      Alternatively our support ticketing system can be used as well: