[SOLVED] J-Flash Programming using batch file

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] J-Flash Programming using batch file

    What I need the batch file to do is:
    1) Open J-Flash
    2) Open .jflash project
    3) Open .srec file
    4) F7 - Production programming
    5) F9 - Start Application

    My batch file as below:
    path C:\Program Files (x86)\SEGGER\JLink_V622a
    JFlash.exe -openprjC:\TI_LM3S9D90.jflash -openC:\v01.01.00.srec -auto -exit

    By using -auto, the batch file is able to do until F7 step, but it cannot do F9 (Start Application).
    May I know how to make batch file perform the F9 in J-Flash?

    Thanks & Best Regards,
    EK
  • Hello,

    Thank you for your inquiry.
    Normally -auto will execute all settings that you set in your J-Flash project under production, the same goes for the "Start Application" option under tab Production.
    How are your settings there? Could you post a screenshot or send us your jflash project for verification?
    The J-Link software version you are using is rather outdated. Could you try the latest one and report back if the issue persists?

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.