Hi guys,

We recently purchased a J-Trace Pro v2 for use in a project involving an NXP i.MX 1060 (namely the MIMXRT1060-EVK) and we're running into some difficulties in configuring the debugger alongside Keil MDK.

We're running into the following issues:

• Unable to load code straight into and run from SRAM (receive an error message that no flash algorithm is available).
  
• We have been able to get QSPI to load and boot but strangely we sometimes have to connect to the device first with J-Link Commander otherwise we receive the error that the AIRCR can not be read.
  
• Although we've been able to get SWO trace working (confirmed by sending over ITM characters), we're unable to use Keil's Logic or System Analyser to track changes in variables/state in real-time.
  

Has anyone had experience with the NXP i.MX RT platform and is able to offer up any solutions/suggestions/best-practises to the points above? In particular we are very eager to resolve the last point as it's critical to our project.

Many thanks