[ABANDONED] J-Link Ultra+ Not Connecting to NRF52832_XXAA

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] J-Link Ultra+ Not Connecting to NRF52832_XXAA

    Hi,
    I am seeing very odd behavior from my J-Link Ultra+ (HW version 4.4). I am using MacOS 10.13.6 and the JLinkExe application, I am able to connect to our STM32F4 MCU (device STM32F469AI). We also have a Nordic NRF52832 MCU. I am not able to connect to the Nordic (device NRF52832_XXAA). Oddly enough, when I switch to another J-Link Ultra+ (HW version 4.3), I am able to connect to both MCUs. Attached is output from both J-Link Ultra+ (I x'd out the last 3 of serial numbers). Please Advise.
    Thanks,
    Jeff
    Files
  • Hello,

    Thank you for your inquiry.
    Such an issue is not known to us.
    Did you use the same USB cable for both J-Links?
    Are you using the same JTAG cables to the target?
    Could you provide a J-Link log file for each case? wiki.segger.com/Enable_J-Link_log_file

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.