[SOLVED] Debugging stops with: Error reading from memory

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Debugging stops with: Error reading from memory

    Hi,

    I am using an NRF52 board with SEGGER studio V3.5 and JLINK (latest firmware) on MAC OSX. I am seeing an intermittent issue where the debug session terminates with a dialog box displaying "Error reading from memory". It is not consistent but happens with some regularity.

    Any ideas what might be causing this?

  • Hello,

    Thank you for your inquiry.
    Such an issue is not known to us.
    Are you using custom hardware or an eval board?
    Does your application use any low power modes or WFIs ?
    Could you provide a J-Link log file of the failed session?
    wiki.segger.com/Enable_J-Link_log_file

    Best regards,
    Nino
    Please read the forum rules before posting: Forum Rules

    Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support contact us per e-mail.
    Alternatively our support ticketing system can be used as well: segger.com/ticket/
  • Hello,

    Thank you for the update.
    Great to hear that you are up and running again.
    We will consider this thread as solved now.

    Best regards,
    Nino
    Please read the forum rules before posting: Forum Rules

    Keep in mind, this is not a support forum. Its main purpose is user to user interaction.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support contact us per e-mail.
    Alternatively our support ticketing system can be used as well: segger.com/ticket/